Using the Student Activity Center Audio:

• The following will guide you through using the SAC Audio system.
• The illustration below shows all the devices you will interact with.
  • This is located in the rear of the Gym Room 119

Selecting your audio source and Zone:

• Start by selecting the area you would like to hear audio in, by pressing one of the Zone Selection buttons.
• Then rotate the Input Selector dial until the desired input is illuminated. Then press the dial in to make the selection.
  • The inputs are as follows:
    • “Gym”: The input box located in the South Bleachers
    • “RF Mic”: The Wireless Microphone
    • “Balcony”: The input box located at the North Balcony
    • “FRT Desk” The input box located at the Front Desk (the usual location for music)
• Use the Volume dial to adjust the volume to the desired level of each zone.

• Repeat the previous steps to select the audio source in each zone.

• Note: If audio is not needed in a particular zone.
  • Select the zone that audio is not needed using the Zone Selection buttons
  • Turn the volume of that zone all the way down, or select and unused input using the Input Selector.
  • Repeat these steps for any zone that audio is not needed.

Other information:

• The “Gym”, “Balcony”, and “FRT Desk” inputs have multi-input wall plates. The following illustration describes the available connections.
  • Ground Lift: Use to eliminate any unwanted “buzzing” in the audio
  • Line input: Use to connect an audio source such as a music player
    • RCA
    • 3.5mm
  • Line Input Volume: Adjust the volume of the line inputs
  • XLR Mic Input:  Connection for a standard XLR Microphone.
• It is recommended that the Audio Amps in the SAC Audio Rack remain turned all the way up and all adjustments be made from the Audio Control Panel.